Ultrasonic Flow Meter KTM700 RUS ®
Commercial metering of natural gas, oil-dissolved gas and hydrogen
Benefits:
- Operating pressure (excess) to 45 МPа at turned solid design;
- Turned solid versions to DN1400;
- Metering of hydrogen H2 and pure gases;
- Metering of fume-laden and humid gases, gases with high content of mechanical impurities (UGS);
- Metering of corrosive gases (made from designated stainless steels: Monel*, Hastelloy** and other at customer’s request);
- Compensation of housing geometric dimesions change by temperature and pressure;
- Measurement error to ± 0.5%;
- Simulation calibration period ±0.7%;
- Calculation of gas mass flow rate without a density meter by “Hydrocarbon” method;
- Separate calculation for the Customer and the Consumer with two independent meters in one housing (Quadro version);
- CMC;
- Possibility of sensors replacement under operating pressure;
- Service life – 20 years.
* is a trademark owned by Special Metals Corporation
** is a trademark owned by Haynes International
METROLOGY AND TECHNICAL CHARACTERISTICS
| Parameter name | Parameter value | Remark |
| Inside diameter, mm |
from 50 tо 1400 |
|
| Lengths of straight sections |
5 х DN 10 х DN 20 х DN |
If an orifice box is available
After leadaway in 1 plane
After leadaway in 2 planes |
| Medium temperature, 0C |
-70 .. +180 |
Extended range: -194…+280 |
| Medium excess pressure, МPа |
from 0 to 28 |
Extended range: tо 45 |
| Untrasound sensors operation frequency, kHz |
80; 135; 200; 350 |
With deviation ±5% |
| Number of measurement channels |
1P(parallel arrangement)
2P(parallel arrangement)
4P(parallel arrangement)
8P(parallel arrangement)
2+2 (quad version) 2Q
4+4 (quad version) 4Q
|
|
| Limits of gas volume flow rate measurement relative error under operating conditions, % | ||
|
Qmin<Q<Qt |
±0.7* |
|
|
Qt<Q<Qmax |
±0.5 |
|
| Calibration interval, years |
4 |
|
| Number of information processing units (IPUs) |
1,2 * |
* — depending on a version |
| Ambient temperature, °С |
-40 ..+60 |
Extended range: -65…+65 with a thermal cover |
| IP degree of protection according to GOST 14254 (IEC 60529)
-Information processing unit with transmitter-receiver units; -Remote module |
IP66/IP67 IP54 |
|
| Explosion-proof marking |
1 Ex db eb ia [ia Ga] IIC T6…T2 Gb X |
|
| Outputs and interfaces |
— frequency (time period signal TPS)/pulse output; — analog configurable output, current loop with support of HART; — RS-485 with support of Modbus RTU and Modbus ASCII; — Ethernet with support of Modbus TCP; — analog input for temperature and pressure sensors, current loop with support of HART |
|
| Power voltage, V |
12…30 |
|
| Input power, W |
Not more than 6 |
|
| Mean time to failure term, h |
88000 |
|
| Service life, years |
20 |
Standard sizes and flow ranges
| Meter diameter | Gas flow rate in operating conditions m3/h | Gas velocity, m/s | ||
|---|---|---|---|---|
| Qmin | Qт | Qmax | Vmax | |
|
DN50 |
1 |
13 |
400 |
65 |
| DN80 | 5 | 40 | 1000 | 61 |
| DN100 | 8 | 65 | 1600 | 63 |
| DN150 | 16 | 100 | 3000 | 52 |
| DN200 | 20 | 160 | 4500 | 44 |
| DN250 | 25 | 240 | 7000 | 44 |
| DN300 | 35 | 310 | 8000 | 39 |
| DN350 | 45 | 420 | 10000 | 36 |
| DN400 | 60 | 550 | 14000 | 38 |
| DN450 | 100 | 700 | 17000 | 37 |
| DN500 | 130 | 850 | 20000 | 35 |
| DN550 | 150 | 1000 | 24000 | 35 |
| DN600 | 180 | 1200 | 32000 | 39 |
| DN650 | 240 | 1400 | 35000 | 36 |
| DN700 | 280 | 1700 | 40000 | 36 |
| DN750 | 320 | 1900 | 45000 | 35 |
| DN800 | 360 | 2200 | 50000 | 34 |
| DN850 | 400 | 2500 | 55000 | 33 |
| DN900 | 450 | 2800 | 66000 | 36 |
| DN950 | 500 | 3100 | 70000 | 34 |
| DN1000 | 550 | 3400 | 80000 | 35 |
| DN1050 | 600 | 3800 | 85000 | 34 |
| DN1100 | 650 | 4100 | 90000 | 32 |
| DN1150 | 700 | 4500 | 95000 | 34 |
| DN1200 | 750 | 4800 | 100000 | 30 |
| DN1300 | 900 | 5600 | 110000 | 28 |
| DN1400 | 1000 | 6500 | 130000 | 27 |
Notes:
Qmin – minimal flow rate;
Qmax — maximal flow rate;
Qt — limit flow rate;
Vmax — maximal gas velocity;
Vt — limit gas velocity= 1,5 m/s